Screaming Circuits: Mistakes Were Made - Too Much Ground Isolation

PROTOTYPE AND SMALL VOLUME
PCB ASSEMBLY MADE EASY

Mistakes Were Made - Too Much Ground Isolation

I recently ran a batch of my Neo Pixel clock boards through the factory here. It's an Arduino UNO-based design that I made for myself not long ago. It sports an Atmega328P, with bootloader, an FT231X USB chip, and a DS3231 real time clock (RTC) chip. Pretty standard stuff. It doesn't even use small parts. All the passives are 0805 size. There's nothing exotic here. So, where did I go wrong?

I also used my 3D printer to make a clock frame to hold this board and a 60-pixel ring of NeoPixels, from Adafruit. I found that with the micro USB connector on the top of the board, it's a little awkward to plug in the USB cable, so I put pads for the connector on the back side of the board. Depending on exactly where and how the board will be used, the micro-USB, button switches, and clock backup battery can all go on either the front or back surface of the board.

Programming the bootloader worked as expected, so I assumed it was just a job well done. Except it wasn't. When I plugged in the micro USB cable, the RX and TX LEDs flickered briefly, but the board wasn't recognized by my PC.

Take a look at the back side of the PC board and see if you can find my mistake - spoilers after the photo.

Back side 1280

I ran a 24 mil trace around the back side of the board to supply power to the NeoPixels. That's not a problem, except that I closed the loop on that trace, and didn't put a path for the ground to get across the trace.

Follow it around, and notice that the ground connections to the u-USB connector don't go anywhere except to this part of the plane. Ugh.

Duane Benson
Cassini's gone now.

Comments

Hi Duane... Any reason why this was not picked up in DRC? I would think that if nets were not connected this is something that should be picked up. I'm curious...

I couldn't spot it from the photo!

Post a comment

If you have a TypeKey or TypePad account, please Sign In.

« QFN Center Pad revisited | Main | Last Minute DFM - Are You In Portland, October 4th? »