Screaming Circuits: That Final Check...


That Final Check...

I'm not talking about the final check that you get from an employer laying you off due to outsourcing. That's a bummer of a final check. The final check I'm talking about is a good thing. It always pays to do this kind of final check. Of course the other kind of final check pays too, but only once. This kind can pay off numerous times.

Here's the scenario: I have an MCU board that can take 5v power from either USB or from a dedicated power source. I want part of the board to receive power all the time and one small high-current section Schematic wrong pwr source to receive power only from the dedicated power source. I don't want to suck too much current out of a poor little USB.

My circuit has three different power busses: USB regulated 5V, on board regulated 5V, on board 9-12V. I even fabbed up some PCBs and built a first prototype. It needed a few mod wires, but I missed this problem. After my mods shown on the older posts, the circuit still worked, so I stopped looking for problems.

Fortunately, I took one last look before sending off for v2 PCB. Two of my bypass caps went to the wrong supply (they were supposed to go the "BRD5V" instead of "5V"). Not a huge deal and in my test set-up, it didn't prevent the circuit from working, but who knows what would have happened in real use. In any case, it would either resulted in another board spin or left the potential for intermittent problems when in use.

Duane Benson
Once again, time for oatmeal

TrackBack

TrackBack URL for this entry:
http://www.typepad.com/services/trackback/6a00d8341c008a53ef0147e364731a970b

Listed below are links to weblogs that reference That Final Check...:

Comments

Post a comment

If you have a TypeKey or TypePad account, please Sign In.

« Virtual Questions | Main | Something Free at ESC »